The camera follows the mobile tag based on the angle of arrival of its RF signal at the anchor point.
Bluetooth location prior to Bluetooth 5.1
The illustrations below demonstrate how Bluetooth low energy technology prior to Bluetooth 5.1 is commonly used in indoor environments. These include industrial, commercial, and retail locations, as well as cultural venues such as museums. To the left, a client carrying a Bluetooth-enabled device is located inside a room with a Bluetooth anchor that receives advertising messages from the mobile device. To the right, the room is equipped with multiple anchors. Both approaches leverage the RSSI, a measurement of the strength with which the signal is received.
In the case with only one Bluetooth anchor node, the client can be roughly located within a certain distance of the anchor. This approach has been used to implement proximity solutions that detect whether a client has entered a target area, e.g. in a shopping center or a museum. When several Bluetooth anchors are present, complex algorithms such as trilateration can be used to more accurately determine the client’s position relative to the anchors.
Bluetooth positioning with direction finding
As outlined in the introduction, Bluetooth direction finding makes it possible to determine the direction that radio signals travel between the mobile client and one or several fixed anchor points. Bluetooth has developed two solution architectures, one based on the radio signal’s angle of arrival (AoA) at the anchor point, the other based on its angle of departure (AoD).
Direction finding – Angle of arrival (AoA)
In the case of AoA, the mobile asset is equipped with a tag that transmits a Bluetooth direction finding signal, which includes a constant tone extension packet (CTE). In this scenario, measurements made by the antenna arrays are used to determine the angle of the incoming signals using a network-based engine. As illustrated below, the signals transmitted by the mobile client reach the individual antennas that comprise the anchor’s multi-antenna array with a slight phase shift relative to the rest. Assuming that the signal propagates a planar wave, the slight phase differences observed at each antenna can be used to calculate its angle of arrival.
Using phase differences to derive the angle of arrival. Adapted from Bluetooth SIG
AoA can be used to implement real-time location services (RTLS) or tracking use cases.
Direction finding – Angle of departure (AoD)
In the case of AoD, the mobile client receives Bluetooth direction finding signals transmitted by one or several antenna arrays. In this case, the mobile client uses measurements of the incoming signal to compute the signal’s direction of departure from the antenna array. Using AoD, the direction finding signals transmitted by each element of the anchor’s antenna array reach the client with a slight phase difference relative to the rest. With information on the geometry of the antenna arrays, the client can calculate the angle of departure of the signal from the antenna array using the measured phase differences.
Using phase differences to derive the angle of departure. Adapted from Bluetooth SIG
AoD can be used to implement navigation and wayfinding use cases.
Direction finding with a single anchor
An indoor positioning setup may use a single anchor featuring a multi-antenna array. This setup can be used to determine, for example, on which side of a fixed anchor node the mobile client is located.
Direction finding with multiple anchors
Multiple static anchors featuring multi-antenna arrays can be used to meet the needs of use cases with more demanding requirements in terms of accuracy. In this case, the position of an asset can be calculated accurately through triangulation, using the angle of the incoming or outgoing signals from several anchors and determining where they intersect.
Indoor positioning demo
